AXIOMTEK UST510-52B-FL Series User Manual page 70

UST510-52B-FL Series user's Manual
BIOS menu item
Activate Voltage Trigger
Low Voltage Trigger
Shutdown Delay Timer
(Low Voltage)
IGN Trigger
System Turn On Delay
Timer (IGN On)
Shutdown Delay Timer
(IGN Off)
POE Configuration
Power over Ethernet (PoE) describes any of several standard or ad-hoc systems which pass
electric power along with data on twisted pair Ethernet cabling.
This menu allows users to set the power level and enable/disable a specific port.
62
Description
The system only turns on when the voltage delivered by the
power source is higher than the value you set here.
The system will begin countdown stage once voltage drops
below the value you set here.
If the power source voltage does not come back above the
value of [Activate Voltage Trigger] within the time you set for
[Shutdown Delay Time (Low Voltage)], the system will shut
down and remain off.
The counter will be activated once power source voltage
drops below the value defined in [Low Voltage Trigger]. The
system will be forced to turn off once timer completes
countdown.
Enable
IGN signal will trigger [System Turn On Delay] and
[Shutdown Delay].
Disable
IGN signal will not affect any power management.
When receiving the IGN signal, the system will be turned on
after setup time is counted down.
The counter will be reset if IGN is off and on during the
system countdown time.
When the system is on, IGN voltage goes off, and the system
will be gracefully shut down by the operating system after
being triggered by the setup timer signal within the time you
set.
Additionally, if power source voltage is lower than the setup
value it will cause the system to turn off as well.
BIOS Setup Utility