Table of Contents
Advertisement
Using Waves (Wave Mode)
Never turn off the power of the VC-2 (V-Synth) while
performing an operation in Wave mode. Doing so may
destroy the files.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch <WAVE>.
The Wave screen appears.
You must save after performing operations in this screen.
When you touch <Save> in the screen, the Disk Save
Project screen will appear, allowing you to save the
project from the work area onto the VC-2 card. For the
rest of the procedure, refer to step 4 and following of
"Saving a Project to the VC-2 Card (Save Project)" (p.
38).
32
Importing Individual Wave
Files (Wave Import)
You can import individual wave files into the work area.
The data will be imported into unused wave numbers.
Importing is not possible if there are no empty wave
numbers.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch <WAVE>.
The Wave screen appears.
3. Touch <Import>.
The Wave Import screen appears.
4. Touch <Int> if you want to import from internal
memory, or touch <Card> if you want to import
from a VC-2 card.
5. From the file list, select the file that you want to
import.
Here you can use the following functions. Touch the
appropriate button to execute.
Prevw: Preview (audition) the selected file (.wav/.aif).
Info: View information for the selected file.
Mark All: Mark all files/folders in the file list.
Mark: Mark the selected file/folder in the file list.
Open: Open the selected folder.
Close: Move to the next higher folder.
6. Touch <OK>.
A WARNING window appears.
If you want to cancel the procedure at this point, touch
<CANCEL>.
7. Touch <EXECUTE> to execute the operation.
Advertisement
Table of Contents
