Table of Contents
Advertisement
Saving and Loading Projects (Disk Mode)
Never turn off the power of the VC-2 (V-Synth) while
performing an operation in Disk mode. Doing so may
destroy the files.
Saving a Project to the VC-2
Card (Save Project)
Save the project in the work area to the VC-2 card.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch <DISK>.
The DISK UTILITY MENU window appears.
3. Touch <Save Project>.
The Disk Save Project screen appears.
4. Select the save-destination project.
If you want to save the data as a new project, touch <New
Project>. The PROJECT Name window will appear.
Assign a name to the new project.
5. Touch <OK>.
A WARNING window appears.
If you want to cancel the procedure at this point, touch
<CANCEL>.
6. Touch <EXECUTE> to execute the operation.
When the operation is completed, the display will briefly
indicate "COMPLETED!."
7. Press [EXIT] to exit Disk mode.
38
Loading a Project from the
VC-2 Card into the V-Synth
(Load Project)
This function loads a project on the VC-2 card into the V-
Synth's work area.
When a project is loaded, work area will be rewritten. If
work area contains important data, you must save it to
VC-2 card before you load other data.
1. Press [MODE].
The VC-2 MODE MENU window appears.
2. Touch <DISK>.
The DISK UTILITY MENU window appears.
3. Touch <Load Project>.
The Disk Load Project screen appears.
4. Select the project that you want to load.
5. Touch <OK>.
A WARNING window appears.
If you want to cancel the procedure at this point, touch
<CANCEL>.
6. Touch <EXECUTE> to execute the operation.
When the operation is completed, the display will briefly
indicate "COMPLETED!."
7. Press [EXIT] to exit Disk mode.
Advertisement
Table of Contents
