Table of Contents
Advertisement
Using Waves (Wave Menu)
Never turn off the power of the VC-2 (VariOS) while
performing an operation in Wave menu. Doing so may
destroy the files.
1. Press the [MENU] so it's lighted, and access the
MENU screen.
If you don't see Menu in the upper left of the screen and
Patch in the lower left, press [EXIT] until they appear.
2. In the top menu screen, move the cursor to
Wave.
3. Press the VALUE knob.
You must Save after performing operations in this menu.
Open Save Project from the Disk menu, and save the
project from the VariOS's memory onto the VC-2 card.
Refer to "Saving a Project to the VC-2 Card (Save
Project)" (p. 63).
Importing Individual Wave
Files (Import)
You can import individual wave files into the VariOS's
memory.
The data will be imported into unused wave numbers.
Importing is not possible if there are no empty wave
numbers.
1. Move the cursor to Import.
2. Press the VALUE knob.
3. Turn the VALUE knob to select the location to
which you want to import the data.
62
[Patch] indicates the Patch folder of the current project.
[Wave] indicates the Wave folder of the same project.
[..] indicates the next higher level.
4. Press the VALUE knob.
Repeat steps 3–4 to move between levels.
5. Turn the VALUE knob to select the file.
The file name of the patch or wave will be displayed.
If there is no file, only the [..] indication will appear when
you turn the VALUE knob.
You can press the VOLUME knob to audition (preview)
the wave.
6. Press the VALUE knob.
The display will ask "Import OK? Push ENTER."
7. Press the VALUE knob to import the data.
Deleting a Wave (Delete)
1. Move the cursor to Delete.
2. Press the VALUE knob.
3. Turn the VALUE knob to select the wave that
you want to delete.
4. Press the VALUE knob.
The display will ask "Wave Delete OK? Push ENTER."
5. Press the VALUE knob to delete the data.
Advertisement
Table of Contents
