Power Off An Sgi Uv 3000 System - Silicon Graphics UV 3000 User Manual

Power off an SGI UV 3000 System

007-6402-001
uvcon: connection to RMC (localhost) established.
uvcon: requesting baseio console access at r001i01b00...
uvcon: tty mode enabled, use 'CTRL-]' 'q' to exit
uvcon: console access established
uvcon: RMC <--> BASEIO connection active
************************************************
******* START OF CACHED CONSOLE OUTPUT *******
************************************************
******** [20100512.143541] BMC r001i01b10: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b07: Cold Reset via NL
broadcast reset
******** [20100512.143540] BMC r001i01b08: Cold Reset via NL
broadcast reset
******** [20100512.143540] BMC r001i01b12: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b14: Cold Reset via NL
broadcast reset
******** [20100512.143541] BMC r001i01b04: Cold Reset via NL....
Note: Use CTRL-] q to exit the console when needed.
Depending on the size of your system, it can take 5 to 10 minutes for the UV 3000 system to boot
to the EFI shell. When the shell> prompt appears, enter fs0: as in the following example:
shell> fs0:
At the fs0: prompt, enter the Linux boot loader information, as follows:
fs0:> /efi/suse/elilo.efi
The ELILO Linux Boot loader is called and various SGI configuration scripts are run and the
SUSE Linux Enterprise Server 12 Service Pack x installation program appears.
To power down the UV 3000 system, use the power off command, as follows:
RMC:> power off
==== r001i01c (PRI) ====
Controlling the UV 3000 System
17