JUMO miroTRON Operating Manual page 61

Parameter Value
Cancellation sig- Digital selector
nal see page 39
Stop signal
Restart signal
Output signal High active
Low active
Actual value Analog selector
tolerance band see page 40
Setpoint value
tolerance band
Tolerance band 0 to 9999
Default setting Description
No selection Signal (active for rising edge) to abort the
timer
The cancellation signal only works during
the runtime (not during the after-run time)
No selection Signal (high active) for stopping the timer
The stop signal only works during the
lead time and runtime (not during the af-
ter-run time).
No selection Signal (active for rising edge) to reset and
restart the timer
The restart signal only works during the
runtime (not during the lead time or after-
run time); it cannot be used to start the
timer
The lead time is not considered in case of
a restart
High active Output signal: high active while timer is
running
Output signal: low active while timer is
running
0 Actual value for tolerance band function
0 Setpoint value for tolerance band function
0 Standard tolerance band (in Kelvin)
around the setpoint value
After the timer is started, the timer time
only runs from the point in time when the
actual value reaches the tolerance band
0 = Start without tolerance band
7 Configuration
61