Connection Diagram - JUMO miroTRON Operating Manual

Electronic thermostat with pid two-state controller function

Hide thumbs Also See for miroTRON:

Table of Contents

5.3

Connection diagram

CAUTION!

Risk of device damage

If the device is not supplied with the voltage specified on the nameplate, this could cause damage to the

device.

 Only supply voltage from a voltage source that matches the specifications on the nameplate.

CAUTION!

In unfavorable conditions, the temperature may exceed 60 °C at the terminals.

As a result, the insulation of the lines connected at the terminals may be damaged.

 The affected cables must be heat-resistant up to at least 80 °C.

 Relay (10 A, 4 × 2.5 A): the affected cables must be heat-resistant up to at least 85 °C.

NOTE!

Only copper conductors are allowed to be connected to the terminals.

5 Electrical connection

Table of Contents

701080 701081