Display And Operation - JUMO miroTRON Operating Manual

7.3.2

Display and operation

Display/operation with the setup program
The settings for the display/operation of the device are specified in this menu.
Parameter
Display
Display 1
Message text 1
Message text 1
signal
Display 2
Message text 2
Message text 2
signal
Display change
upon timer start
Run
speed
Operation
Short-press back
button (< 3 s)
Long-press back
button (> 3 s)
Operation timeout 0 s, 30 to 180 s
Auto save
Value
Analog selector,
see page 40
(editable)
Digital selector,
see page 39
Analog selector,
see page 40
(editable)
Digital selector,
see page 39
No function
Timer remaining run-
ning time
Timer runtime
0 to 4
No function
Display timer value
Start manual mode
Start autotuning
No (empty)
Yes (check)
Default setting Description
Analog input Display value of the upper LED display
(white)
Is displayed as soon as the message text
1 signal accepts the logic level "1".
Is not displayed if the message text 1 sig-
nal accepts the logic level "0".
No selection Setting for which value is to trigger mes-
sage text 1.
Setpoint value Display value of the lower LED display
1 (green)
Is displayed as soon as the message text
2 signal accepts the logic level "1".
Is not displayed if the message text 2 sig-
nal accepts the logic level "0".
No selection Setting for which value is to trigger mes-
sage text 2.
Timer remain- Display changes when timer is started
ing running
No display change
time
Display of the remaining running time
Display of the runtime
4 "4" corresponds to the fastest running
speed
No function Function of the "Back" button in the basic
status when short-pressing the button
(less than 3 seconds)
Additional functions of the button can be
selected in the configuration of the indi-
vidual device functions (digital selector,
see page 40).
No function Function of the "Back" button in the basic
status when long-pressing the button
(longer than 3 seconds)
180 s Time period (in seconds), after which the
device automatically returns to the basic
status if no key is pressed.
No (empty) The "Menu/OK" button must be pressed
to exit editing mode with the acceptance
of a change.
Editing mode is automatically exited after
a certain time and a change is accepted
7 Configuration
45