Standby Mode; Time Formats - JUMO miroTRON Operating Manual

6 Operation
NOTE!
The controller automatically changes to manual mode in the event of overrange or underrange, even if
manual mode is disabled or inhibited.
6.10

Standby mode

In standby mode, the device controller sets all of the digital outputs to inactive/deactivated and switches
the controller off. The device initiates standby mode via a configurable digital signal. If the digital signal
= high, standby mode is active.
The device signals standby mode via the flashing 2nd display "STANDBY".
6.11

Time formats

The time format can be configured for the timer function:
MM:SS - Minutes:Seconds
HH:MM - Hours:Minutes
DD:HH - Days:Hours
Time formats on the device are configured in the menu
>CONFIGURATION/TIMER/TIME DISPLAY.
It is only possible to set these when the timer is switched on.
1. Navigate to the CONFIGURATION/TIMER/TIME DISPLAY menu.
2. Press OK/MENU.
The 2nd display with the time format flashes.
3. Use DOWN or UP to select the desired time format.
4. Press OK/MENU.
The 2nd display stops flashing.
5. Press the Back button 3 x to return to the basic display.
The time format for the timer is set
38