JUMO miroTRON Operating Manual page 46

7 Configuration
Parameter
Setpoint value
adjustment
Start delay time
Level
inhibit
?
Level inhibit
See chapter chapter 6.7 "Level inhibit", Page 37
Display/Operation on the device
The following settings for display/operation can also be carried out on the device.
Parameter
Display 1
Display 2
Display change
upon timer start
Short-press back
button (< 3 s)
Long-press back
button (> 3 s)
Time-out
Operation
Auto save
Setpoint value
adjustment
46
Value
Yes (check)
No (empty)
0 to 300 s
None
Configuration
Complete
Value
Analog selector,
see page 40
No function
Timer remaining run-
ning time
Timer runtime
No function
Display timer value
No function
Display timer value
0 s, 30 to 180 s
No
Yes
No
Yes
Default setting Description
Yes (check) The current setpoint value can be entered
directly in the basic status using the "Up"
and "Down" buttons
Setpoint value adjustment is not allowed
in the basic status.
0 s Start delay time (in seconds) after Power
ON.
All functions of the device are only active
after this time has elapsed.
None Access to the individual levels can be in-
hibited:
No level inhibited
Configuration level inhibited
Configuration level and user level locked
Default setting Description
Analog input Display value of the upper LED display
(white)
Setpoint value 1 Display value of the lower LED display
(green)
No function Is used on the device and in the setup
program.
No function Function of the "Back" button in the basic
status when short-pressing the button
(less than 3 seconds)
Additional functions of the button can be
selected in the configuration of the indi-
vidual device functions (digital selector,
see page 39).
No function Function of the "Back" button in the basic
status when long-pressing the button
(longer than 3 seconds)
180 s If no key is operated after this time, the
device reverts to the basic status
No Editing mode is automatically exited after
a certain time and a change is accepted
Yes Setpoint value adjustment is not allowed
in the basic status
The current setpoint value can be en-
tered directly in the basic status using the
"Up" and "Down" buttons