Tig "Ac" Welding - CEA MATRIX X220 AC/DC Operator's Manual

TIG "AC" Welding

Via the welding process configuration menu, set:
• TIG AC welding process with HF ignition.
• Welding mode.
• Type of pulsation.
• Type of AC wave shape.
The possible parameter combinations are as follows:
WELDING
PROCESS
DEFAULT
2T
TIG AC 4T AUTO
(*) Advance welding mode can be activated as follows:
• CONFIGURATION menu
• WELDING section
• 2T-4T AUTO ADV line
• Choose ACTIVE
When the key is pushed, the welding page opens:
An example of complete configuration of all the parameters is shown below:
Push the knob to enter the SET page.
Push and rotate the knob to set the following parameters:
12 6 7 8 4 2
NOTE: If the BACK key is held down for 2 seconds, the parameter goes back to its default setting.
WELDING MODE
ADVANCE
2T ADVANCE (*)
4T
4T AUTO
ADVANCE (*)
CYCLE
SPOT
3 1 5 9 10 11
PULSED MODE
X X
X X
X X
X X
13
14
15
16
10
TYPE OF AC WAVE
X X X
X X X
X X X
X X X
X X X
X
X
X
X
X