MAIN MENU
MAIN SUB-MENU
REMOTE MODE
MAX PRE-GAS
MAX SLOPE-UP
REMOTE FLOOR
MAX SLOPE-DOWN
MAX POST-GAS
MAX SPOT
COOLING
ANTI-STICK
WELDING
AC START
IGNITION
2T-4T AUTO ADV
OCV-R
REIGNITION
JOB SCAN
GAS TEST
DURATION
PARAMETERS /
DEFAULT
HIGH - LOW LIMIT
VALUE
REMOTE DISABLED
MANUAL CONTROL
PEDAL CONTROL
POTENTIOMETER
TORCH
1,0 s (1,0-2,50)
1,0 s
5,0 s (5,0-10,0)
5,0 s
5A (1-220) -
MATRIX X220
5A (1-300) -
MATRIX X300
8,0 s (8,0-15,0)
8,0 s
25,0 s (10,0-25,0)
25,0 s
25,0 s (10,0-25,0)
25,0 s
ON DEMAND
ALWAYS ON
ALWAYS OFF
ACTIVE
INACTIVE
POSITIVE
NEGATIVE
TIP-SIZE
MANUAL
INACTIVE
ACTIVE
INACTIVE
ACTIVE
AT START UP
ALWAYS ON
ALWAYS OFF
INACTIVE
ACTIVE
15 s (5-60)
28
NOTE
X
Allow disabling / re-enabling of the remote control
used
Maximum settable PRE-GAS time limit
Maximum settable SLOPE-UP time limit
Minimum settable remote control current limit.
WARNING: If the minimum limit setting (for the re-
mote control MINIMUM CURRENT) is greater than
5 A
or equal to the value for the I
RENT, you will weld at the I
RENT, irrespective of the setting you have chosen
on the remote control.
Maximum settable SLOPE-DOWN time limit
Maximum settable POST-GAS time limit
Maximum settable SPOT WELDING time limit
ON DEMAND cooling on in automatic mode.
X
During welding or for a certain period of time after
this is finished.
Cooling always on
Cooling always off
X
Anti-sticking mode active or deactivated for all
processes
X
AC ignition mode with positive or negative polarity
Automatic TIG ignition current regulation, based on
X
the electrode size chosen
Manual setting of the current and duration of the
ignition time
X
Enabling 2/4 touch STANDARD or AUTO
ADVANCE
Enabling the OCV-R device for MMA welding
X
Reduce the voltage without load between the
output terminals (<35V) when the welding machine
is not in the welding cycle
Activation of this is indicated by the OCV-R
indicator switching on, on the display.
X
Automatic TIG arc reignition mode. It is possible
to choose enabling of automatic reignition within
the first 3 seconds of welding, automatic reignition
enabled throughout welding, or to disable
automatic reignition
When using a standard torch, a single button can
X
be used to go to the next JOB by pushing and
releasing the button within 1 second
15 s
Duration of the welding gas flow test
MAIN welding CUR-
1
MAIN welding CUR-
1
Need help?
Do you have a question about the MATRIX X220 AC/DC and is the answer not in the manual?