Water Cooling System - Norton Clipper CMV 1000 Verto Operating Instructions Manual

VERS. 21.01.2019
Emergency Stop
The main ON-OFF switch can be used as an emergency stop switch!
3.4

Water cooling system


Fill the water tray with clean water through the intake opening (I.) up to approximately 2cm from
top (ensure that bottom of pump is fully immersed in water that the pump not run dry and burn)

Make sure that the water pump plug is connected into the socket (II.) and the water hose
connected to the pump

Plunge the water pump basket down in the water tray (III.)

The rotating saw blade has to be cooled on both side with enough water ... regulate the water
flow with the water tap

Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the
saw blade, as insufficient water supply may result in premature failure of the diamond blade

Do not run the water pump without water ... "dry running" will damage the water pump!

Always make sure that there is enough water in the pan and refill if necessary

In case of frost, empty the water management
CMV 1000 Verto_MAN_EN
19