Operation With The Mc²; Operating And Display Elements; Stop And Go Buttons - tams elektronik mc2 EasyControl Digital System Silver Edition Manual

6. Operation with the mc²

6.1. Operating and display elements

The mc² has a STOP and GO button with which you can trigger essential functions directly on
the unit. To switch the track voltage on and off, you can alternatively click on the photo of the
mc² on the start page ("HOME") of the mc²-Toolbox.
The display on the front provides you with essential information about the operating status of
your mc². In addition, the RGB LEDs built into the housing change colour and thus visibly
indicate the operating status from afar.

6.1.1. STOP and GO buttons

Button Duration
GO short
STOP short
GO long
GO, short,
GO, short,
GO, ... short, ...
STOP long
GO +
long
STOP
off*
when
GO
switching
+ on*
on
off*
when
GO+STOP
switching
+ on*
on
* off: Switching off the power supply
* on: Switching on the power supply while holding down the button(s)
Function
Switching on track voltage
Switching off track voltage
Reading out the IP address
The individual digits of the IP
address are retrieved by pressing
the "GO" key several times.
→ Section 2
Sending BiDiB-Identify for
the mc² (→ registration of
the mc² with the PC
control software)
Reset ausführen
Configuration incl. deleting
the locomotive list and
resetting to factory settings
Starting recovery software
→ section 7
Shown
in the display
0.0 or current power
consumption
St.
IP|
12|3.4|56.|78|9.1|23
St.
rE
Fr
Dots flash alternately
Operation with the mc² | 6.1
Colour of the
RGB LEDs
green
red
red
blue
circulating
blue
flashing
+ white
swelling
red
violet