tams elektronik mc2 EasyControl Digital System Silver Edition Manual page 8

Connection to the power supply
Note:
!
Only use the power supply unit supplied as a power supply for your mc² and the
components of your system that are supplied by the integrated booster.
Note:
!
There is a catch on the unit plug that prevents the power supply connection cable from
being pulled out accidentally. To be able to pull out the cable, you must pull the catch in the
direction of the cable. Never pull the cable out of the socket by force! Doing so may damage
connections in your mc².
Then plug the supplied (black) mains cable into the connection socket of the power supply
unit and into the socket.
Reading out the IP address of the mc²
Press and hold the "GO" button of the mc² until "IP" is shown in the display. If you continue
to press the "GO" key, the digits of the IP address appear one after the other. Tip: Write
down the digits including the dots.
Structure of the IP address: 123.456.789.123
Note: Leading zeros (after a dot) are not shown in the browser display.
Calling up the IP address in the browser
The mc²-Toolbox (i.e. the web interface of the mc²) has been tested with the browsers
Chrome, Firefox, Opera and Edge. The use of the browsers Internet Explorer and Safari is not
recommended, as they do not support all the required functions.
Enter the read IP address in the browser of the PC, tablet or smartphone. The start page
("Home") of the mc²-Toolbox will then open.
2.2 | Commissioning
First, plug the 4-pin connector of the
power supply connection cable into the
"Power" socket on the back of the mc² so
that the flat part of the plug points
upwards.