Accessories - tams elektronik mc2 EasyControl Digital System Silver Edition Manual

Tractions
The control of locomotives in tractions is only possible if the same number of speed steps is
assigned to the decoders. Tractions with vehicle decoders with different data formats are
possible. Possible combinations:

DCC and Motorola decoders with 14 speed steps

DCC decoders with 28 speed steps and Motorola decoders with 27 speed steps

DCC decoders with 128 speed steps and mfx decoders with 126 speed steps
If you form tractions of locomotives with different driving directions, you can invert the driving
direction for one locomotive. In operation, this locomotive will then travel backwards (or vice
versa) when travelling forwards.
Tractions react together under all decoder addresses of the traction to driving commands and
the command to change direction. To switch the functions, the locomotive must be called up
under its respective address.
Further settings in the "Vehicles" menu item

Purging: You can specify that decoders that have not received any new driving or switching
commands within the set time (1 to 20 minutes) are removed from the refresh.

Lnet Dispatch: LocoNet hand controllers are used to control one specific vehicle. If you
have connected such a hand controller to the LNet interface of your mc², assign it "its"
decoder address here.

5.3. Accessories

 Management of the accessory decoders
In this menu item you set how your accessory decoders are to be controlled by default:

Standard format

Minimum and maximum switching time

Number of repetitions of accessory decoder commands
You can also specify for which decoders exceptions to the standard format should apply.
Tip: The input field "Remarks" is intended for your notes on the accessory decoders. You can
enter free texts and save them in external files or load texts from external files.
5.4 | Configuring the system (Submenu "System")