tams elektronik mc2 EasyControl Digital System Silver Edition Manual page 6

Intended use
The digital control unit mc² is intended for controlling digital model railway layouts according
to the information in the instructions (consisting of guide, manual and direct aids). Only the
power supply unit included in the scope of delivery is permitted for the power supply. Any
other use is not in accordance with the intended use and will result in the loss of the warranty
claim. Intended use also includes reading, understanding and following all parts of the
instructions. The mc² is not intended to be used by children under the age of 14.
Safety instructions
Improper use and non-observance of the instructions can lead to incalculable hazards. Prevent
these dangers by carrying out the following measures:

Use the digital control unit and the power supply unit only in closed, clean and dry rooms.
Avoid humidity and splash water in the environment. After condensation has formed, wait
two hours for acclimatisation before use.

Disconnect the control unit from the power supply before carrying out wiring work.

Only plug the mains plug of the power supply unit into properly installed and fused earthed
sockets.

Heating of the control unit and the power supply unit during operation is normal and
harmless. Keep a distance of at least 20 cm between the sides, the top and the back to
surrounding surfaces to allow unhindered air exchange and to predect the units from
overheating.

Do not expose the units to high ambient temperatures or direct sunlight. Observe the
information on the maximum operating temperature in the technical data.

Regularly check the operational safety of the units, e.g. for damage to the connection
cables or damage to the housing.

If you notice damage or if malfunctions occur, switch off the supply voltage immediately.
Send in the control panel and/or the power supply unit for inspection.

Dangerous voltages occur inside the power supply unit. Therefore, never open the housing
of the power supply unit.
Care
Do not use any cleaning agents to clean the mc² and the power supply unit. Only wipe the
units dry. Disconnect the units from the power supply before cleaning.
1.2 | Getting started