Devices For The Easynet - tams elektronik mc2 EasyControl Digital System Silver Edition Manual

4.2.3. Devices for the EasyNet

Info
The EasyNet is the data bus for the EasyControl digital system. Devices and adapters that have
been specially developed for this system communicate via this bus.
Connection: RJ45
Note: The connection of the adapters XNControl, SniffControl or wControl does not make
sense, as corresponding interfaces are integrated in the mc².
Possible applications of the EasyNet input devices
You can use the input devices that you integrate into the digital system via the EasyNet
interface

to control vehicle decoders for Motorola, DCC and mfx (the latter in m3 format)

to switch accessory decoders for Motorola and DCC

to program vehicle decoders and accessory decoders

to configure essential properties of the mc² / the digital system
Note: It is not possible to program decoders or to configure the mc² and the digital system
with input devices that are integrated into the EasyNet via the mControl (Keyboard 6040,
Memory 6043, driving consoles Control 80 or 80F and Infra Control 80F from Märklin).
Power supply of the units at the EasyNet interface
The EasyNet control units HandControl and HandControl.2, LokControl and MasterControl with
configuration as slave are supplied via the bus line. A separate power supply is required for
the mControl adapter and the connected digital devices.
Notice:
!
The total current of all external digital devices that are connected to the various interfaces of
the mc² and do not have their own power supply must not exceed 1.2 A. Otherwise, the
mc² automatically switches off the power supply for the external devices.
4.6 | Connections
For the connection of

HandControl and HandControl 2

LokControl

MasterControl (with configuration as
"slave")

mControl