Table of Contents
Advertisement
Note:
!
If you use other boosters than those previously mentioned to supply your system, you
should not use the integrated booster of the mc² to supply a booster section. Otherwise,
short-circuits and disturbances in data transmission may occur when crossing the separation
points between the sections.
Configuration
Before you start system operation, you must configure the boosters, i.e. set them to match
the nominal size of your system.
→ Section 5.5 in the manual
→ Menu item "System / Boosters"
4.6. Connection to the audio output
Info
The audio output of the mc² is technically correctly designated as a "line-out output". The
line-out signal at the output has a high sound quality.
At present (as of june 2022), the output is not yet supported by the software of the control
unit. With a later software version, it will be possible to store and retrieve background sounds
in the mc². It is also planned to call up situation-specific sounds together with the switching of
functions.
Later software versions will be available for free download from the Tams Elektronik website
at www.tams-online.de.
For the connection of
Active speakers (e.g. typical PC speakers)
Amplifiers in combination with passive loudspeakers
The connection is made via 2.5 mm stereo jack plugs.
4.12 | Connections
Advertisement
Table of Contents
