tams elektronik mc2 EasyControl Digital System Silver Edition Manual page 42

HandControl.prog
The HandControl.prog and the FunctionControl.prog have almost the same functionality as the
standard versions of the virtual controllers and are especially used for testing decoder
settings. However, in test mode (display "td" in the display of the mc²) you can only control
vehicle and accessory decoders on / at the programming track.

HandControl.vi → section 6.3.1

FunctionControl.vi → section 6.3.2
The following functions differ from the standard version of the virtual HandControl:
Change to FunctionControl.prog
Change of the interface for switching accessory decoders at the programming track
Change to HandControl.vi (the standard version of the virtual HandControl)
Testing accessory decoders
Turnout
adress
Turnout
position
Turnout
"straight ahed"
Turnout
"branch"
6.6 | Operation with the mc²
To select the turnout
address, enter the
address via the
number fields.
Afterwards you can
switch between the
two turnout positions
with the buttons
and