tams elektronik mc2 EasyControl Digital System Silver Edition Manual page 9

User settings in the mc²-Toolbox
Set the following on the start page of the web interface of your mc²:

longuage

Display of the submenu items: Change the display by clicking on the symbols.
Submenu items are always displayed
Submenu items are only displayed after clicking on the
higher-level main menu item.
Downloading the manual
Before connecting the mc² to your model railway layout, download the manual from the start
page of the mc²-Toolbox ("Home") and read it carefully. In the manual you will find all the
information you need to connect to your layout and external devices, as well as an overview of
the configuration of your mc² and notes on its operation.
In the manual you will also find the troubleshooting checklist, the technical data of the control
unit and the power supply unit and the warranty declaration.
Before the first test drive
For a first test run you can connect your mc² e.g. to a separate track oval, for which the
integrated booster is sufficient as a power supply, and familiarise yourself with the functions of
the control unit.
You have to do the following things before you can do a first round with a locomotive:

Connect the track output of the mc² to the rails (→ section 4.1 in the manual).

Configure the integrated booster, i.e. set the track voltage and the maximum current for
the nominal width of your layout (→ menu item "System / Boosters").
To control a locomotive, proceed as follows:

DCC decoder: Open the virtual HandControl on the start page ("Home") of the mc²-
Toolbox. Enter the DCC address and control the locomotive. For the functionality of the
HandControl.vi → section 6.3.1 in the manual.

MM decoder: Before you can control a locomotive with the HandControl.vi, you must create
the MM address in the locomotive list and assign an MM format to the locomotive (→ menu
item "System / Vehicles").

mfx decoder: First read out the UID and assign an address to the decoder (→ menu item
"Operation / Programming / m3"). You can then control the locomotive in m3 format with
HandControl.vi.
Commissioning | 2.3