3M -Matic 7000r-I Instructions And Parts List page 128

Adjustments
(continued)
Tape Leg Length
Leading Tape Leg Length Adjustment –
Figure 5-6
The one-way tension roller position is
adjustable to control the leading tape
leg length.
Moving this roller farther away from
the box top or bottom surface will
decrease the leading leg length.
Moving it closer to the box top or
bottom surface will increase the
leading leg length.
Changing Tape Leg Length from 70 to
50mm [2.75-2 Inches] – Figure 5-7
Note – When changing tape leg length,
both upper and lower heads must be
adjusted to apply same leg lengths.
1. Remove and retain two hex head
screws and remove the brush from
normal position "A" on side frame.
2. Remount and secure brush in posi-
tion "A-A" on side frame forward of
normal location with original fasteners.
3. Remove cut-off bracket extensions
from position "B".
4. Remount cut-off bracket extensions
in forward position "B-B".
5. Remove/retain one-way tension roller
assembly from slot "C" in frame.
6. Remount tension roller assembly
near top of slot "C-C" in frame using
original fasteners.
7. Adjust tension roller according to
"Leading Tape Leg Length Adjustment"
above.
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
3M-Matic Accuglide 3 - 2 Inch Taping Head - Type 10800
™
Page 16
44-0009-2070-0 / ECO#0078483
Warning
Original Instructions
Source Document for all related Manuals/Translations
Tape Leg 50 or 70mm ± 6mm
[2 or 2.75in. ± 0.25in.
Figure 5-6 Leading Tape Leg Length
Position A
Position A-A
Position B
Position B-B
Brush
Figure 5-7 Changing Tape Leg Length
Warning
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fingers away from tape
cutoff blades under orange blade guards.
The blades are extremely sharp.
One-Way
Tension
Roller
Slot C-C
Slot C
Cut-Off Bracket
Extension
International - ENG
February 2021