3M -Matic 7000r-I Instructions And Parts List page 36

7. Installation
7. Hold taping head Buffing Roller and
8. Check for free action of both upper
9. Ensure that the tape drum bracket
Buffing
Roller
3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 24
44-0009-2165-8 / ECO# 0078045
(continued)
cut and remove cable tie that holds
applying/buffing arms retracted
(Applying/buffing rollers are held
retracted for shipment - Figure 7-6).
Allow buffing/applying arms to
extend slowly.
Also cut and remove cable tie at
rear of lower taping head.
and lower taping heads. Push
buffing roller into head to check for
free, smooth action of taping heads.
assembly, located on the lower
taping head, is mounted straight
down (Figure 7-8). The tape drum
bracket assembly can be pivoted
to provide tape roll clearance in
certain cases.
C
Cable
Tie
B
Figure 7-7 7000r-I / 7000r3-I Pro Frame Set-Up
• To reduce the risk associated with
- Keep hands and fingers away from
Column Guards
Original Instructions
Source Document for all related Manuals/Translations
Warning
sharp blade hazards:
tape cutoff blades under orange blade
guards. The blades are extremely
sharp.
A
Note:
Column Guads are
removed before Installing
the Bumper Supports.
Column Guards are
then installed.
International - ENG
February 2021