3M -Matic 7000r-I Instructions And Parts List page 57

13. Maintenance and Repairs
Refer to Figure 13-5 and 13-6 and
adjust belt tension as follows:
1. Remove and retain center plates/
2. Loosen, but do not remove, the
3. Reset the tension on the drive belts
4. Replace center plates/front cover
Drive
Belts
3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 45
44-0009-2165-8 / ECO# 0078045
front cover and four (4) screws.
lock nut with an open end wrench.
as needed. Adjust the tension
screws in (clockwise) to increase
tension or out (counterclockwise)
to decrease tension. Tighten lock
nut to secure tension setting.
and secure with original screws.
Center
Flat Head
Plate
Screws (4)
Lock
Nut
Hex
Wrench
Figure 13-5 Box Drive Belt Tension Adjustment, Lower Belts (Infeed End)
(continued)
Socket Hd
Tension
Adjustment
Screw
Original Instructions
Source Document for all related Manuals/Translations
Warning
• To reduce the risk associated with
mechanical and electrical hazards:
- Turn peumatic and electrical supplies off
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
Infeed End
International - ENG
February 2021