Special Set-Up Procedure - Column Bumper Installation - 3M -Matic 7000r-I Instructions And Parts List

13. Maintenance and Repairs
13.11 Special Set-Up Procedure -
Column Bumper Installation
Purpose of Bumper Special Set-up
Procedure: Installing Column Bumpers
restrict operating range of upper
assembly in proportion to box sizes
to be sealed (Figure 13-7A). This
installation limits working cycle time
resulting in increased operating speed.
Installation Instructions - Column
Bumper (a parts package is included
with the unit for installation purposes).
The Column Bumper will be located
on the column according to the size
of the box that is to be taped
(Refer to Figure 13-7A).
1. Raise and Lock the Upper Drive
Important: This procedure is for
2. Turn off air supply/electric power.
3. Remove Guard (see Installation
4. Remove Column Bumper and set
5. Position Bumper as needed
6. After the new Bumper is installed,
7. Turn "On" Electric Power/Pneu-
* Important: See Figure 15983 for
- Some bumper positions may:
These events can potentially cause
damage to machine. For more infor-
mation on bumper settings, contact
your 3M service representative.
3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 47
44-0009-2165-8 / ECO# 0078045
Assembly.
authorized personnel ONLY!
and Set-Up / Section 7), existing
holes/installing Column Bumper
should be visible.
screw parts package from carton.
(the recommended position is
shown in Figure 13-7A).
re-install the Safety Guard (see
Installation and Set-Up Section 7).
matics and press Station "Start"
Button.
Plate Change. When Column
Adjusted to "Raised" Position -
Part #38 is removed and
replaced by Part #13.
1) Allow upper and lower taping
heads to come into contact
with each other.
2) Create added stress to the
bumper.
3) Cause malfunction of machine.
(continued)
• To reduce the risk associated with
- Read, understand, and follow all safety
- Allow only properly trained and
A
Safety Guard
Set Screws
& Washers
Shown is after Safety
Guard is Removed)
Figure 13-7 Case Sealer Frame Changes
Original Instructions
Source Document for all related Manuals/Translations
Warning
mechanical and electrical hazards:
and operating instructions before
operating or servicing the case sealer.
qualified personnel to operate and
service this equipment.
B
C
International - ENG
February 2021