3M -Matic 7000r-I Instructions And Parts List page 125

Maintenance
Cleaning
Regular slotted containers produce a
great deal of dust and paper chips when
conveyed through taping heads. If this
dust is allowed to build-up on the heads,
it can cause wear on the moving parts.
Excessive dirt build-up should be wiped
off with a damp cloth. Cleaning should be
done once per month, depending on the
number and type of boxes used. If the
boxes used are dirty, or if the environ-
ment in which the heads operate is dusty,
cleaning on a more frequent basis
may be necessary.
Note – Never attempt to remove dirt
Applying/Buffing Roller
Replacement
Replacing roller requires removal
of shaft and mounting screws.
With no area on the shaft to grip,
the shaft often turns when attempt-
ing to remove the second screw.
To ease removal of second screw,
a 5mm hex socket has been
provided at the bottom of the
threads in both ends of the shaft.
Insert a 4mm hex key wrench into
this socket after removing one
screw to hold the shaft for removal
of the second screw (See Figure 4-2).
3M-Matic Accuglide 3 - 2 Inch Taping Head - Type 10800
™
Page 13
44-0009-2070-0 / ECO#0078483
(continued)
from taping heads by blowing
it out with compressed air.
This can cause the dirt to be
blown inside components onto
sliding surfaces. Dirt in these
areas can cause serious equipment
damage. Never wash down or
subject taping heads to conditions
causing moisture condensation on
components. Serious equipment
damage could result.
Source Document for all related Manuals/Translations
• To reduce the risk associated with
shear, pinch, and entanglement hazards
- Turn air and electrical supplies off
on associated equipment before
performing any adjustments, mainte-
nance, or servicing the taping heads
- Never attempt to work on the taping
head or load tape while the box drive
system is running
• To reduce the risk associated with
sharp blade hazards:
- Keep hands and fingers away from
tape cutoff blades under orange blade
guards. The blades are extremely sharp.
5mm Hex
Key Wrench
Figure 4-2 Roller Shaft Section View
Original Instructions
Warning
Warning
Hex Socket
Section View of
Roller/Shaft
International - ENG
February 2021