3M -Matic 7000r-I Instructions And Parts List page 61

13. Maintenance and Repairs
13.12 Special Set-Up Procedure for
Outer Column Re-Positioning
(continued)
Moving the outer columns
will increase or decrease the
box height handled by the
7000r-I / 7000r3-I Pro case sealer.
Maximum Height:
An additional adjustment can be
made to reach Maximum Height.
This additional height adjustment
can be made by moving the
Upper Assembly Crossbar up
to top holes - (Figure 13-9).
Box Height Range – (Refer to
Figure 13-8 / Section 7 / and
Specifications).
The operating range of the upper
drive assembly can be adjusted to
minimize its movement (which
increases the operating speed) and
in conjunction with adjusting the
bed height, to change the range of
box heights being sealed.
After establishing the minimum
box height to be sealed, position
the stop bumpers as follows:
1. Latch upper drive assembly in
2. Remove and relocate the stop
3. Turn on the air and electrical
3M-Matic 7000r-I / 7000r3-I Pro - Type 11700
™
Page 49
44-0009-2165-8 / ECO# 0078045
upper position, turn off air and
electric.
bumper assembly to the desired
position on both side columns.
Be sure that the stop bumpers are
reassembled as shown and secure
(Figure 13-7 and Figure 15983).
power to the case sealer.
The upper taping head will now
descend only part way thus
increasing operating speed.
Source Document for all related Manuals/Translations
(continued)
• To reduce the risk associated with
- Turn peumatic and electrical supplies off
• To reduce the risk associated with
− Use the appropriate rigging and
• To reduce the risk associated with
− Always use appropriate supporting
Figure 13-9
Original Instructions
Warning
mechanical and electrical hazards:
and disconnect before performing any
adjustments, maintenance or servicing
the machine or taping heads.
Warning
muscle strain:
material handling equipment when
lifting or repositioning this equipment
impact hazards:
means when working under the
upper drive assembly
International - ENG
February 2021