Using The Setup Wizard - Quantum Scalar i500 User Manual

Using the Setup Wizard

Scalar i500 User's Guide
appropriate screens on both the operator panel and the web client are
given for each task. For the operator panel, the paths refer to the
navigation tabs at the top of the home page. For the web client, the paths
refer to the menus.
For the menu trees on both the operator panel and web client, see
Trees on page 39.
Power cycling (powering the library on and off) is not
Note:
necessary to configure the library.
The Setup Wizard simplifies the process of configuring the library. When
you first power on the library, the operator panel displays the Setup
Wizard. After that, you can no longer access the Setup Wizard from the
operator panel. You can always access the Setup Wizard from the
menu on the web client.
The recommended procedure for using the Setup Wizard for the initial
configuration is as follows:
1 Turn on the library and begin using the Setup Wizard on the operator
panel.
2 Work through all of the screens as prompted (see
on page 51).
3 When you get to the network configuration screens, configure the
network settings as follows:
You cannot log into the web client until you have
Note:
configured the network settings.
•
If you are using IPv4:
NOT select the
network settings.
Chapter 3 Configuring Your Library
On the
Setup Wizard: Enable IPv6
checkbox. Click
Enable IPv6
Using the Setup Wizard
Menu
Setup
Setup Wizard Tasks
screen, do
. Configure the
Next
49