Configuring The Media Integrity Analysis Report - Quantum Scalar i500 User Manual

Configuring the Media
Integrity Analysis Report
Scalar i500 User's Guide
• Selected Drive by Coordinate — The report chart is based on an
individual tape drive location in the library. If more than one
tape drive resided in that location during the selected range, then
the attribute values for all the tape drives that resided in that
location are combined in the chart.
• Selected Drive by Physical SN — The report chart is based on an
individual tape drive identified by its physical drive serial
number.
• Selected Partition — The report chart is based on an individual
partition in the physical library.
You can only access this report from the web client. The path to open the
report is
Reports > Advanced Reporting > Drive Resource Utilization
This report provides TapeAlert count for various combinations of tape
5 drives, tape cartridges, and TapeAlert flags. You can use this report to
help determine if a problem is due to a specific tape drive or tape
cartridge.
The report displays the number of TapeAlerts for the selected Grouping
and combination of Attributes.
The Media Integrity Analysis report collects the following information for
each TapeAlert:
• Cartridge barcode
• Tape drive physical serial number
• Tape alert value
• Occurrence count of each TapeAlert
• Time and date (UTC) of TapeAlert occurrences
To configure the report, specify the following:
• Range — Specifies the range of time covered in the report. Choose
one of the following:
• Last 7 days
• Last 4 weeks (default)
• Last 3 months
• All History (as far back as there is data in the log file)
Chapter 5 Getting Information
Using Advanced Reporting
.
157