Figure 28 Y-Rail In Unlocked, Functional Position - Quantum Scalar i500 User Manual

Figure 28 Y-Rail in Unlocked,
Functional Position
Scalar i500 User's Guide
a From the front of the library, open the I/E station and access
doors of the expansion module. Squeeze the handle of the Y-rail
release mechanism, lift it out of its locked position, and slide it
downward as far as it will go.
b From the back of the library, find the rear Y-rail release
mechanism, which is located in the interior of the right side of the
module. Squeeze the handle of the Y-rail release mechanism, lift
it out of its locked position, and slide it downward as far as it will
go.
Check to make sure that there is no gap between the top
Caution:
and bottom Y-rails on both the front and back of the
library. If a gap exists, the library cannot mechanically
initialize.
Doing this aligns the Y-rails with the Y-rails of the module beneath it.
7 Repeat these steps for each expansion module you are installing.
Chapter 7 Installing, Removing, and Replacing
Installing a New Multi-Module Library Configuration
211