Table of Contents
Advertisement
4
Type "yes" and press ENTER.
You are prompted for the password.
5
Key in the password OverrideWWN and press ENTER.
This causes the SNC to reboot.
6
After the SNC has rebooted, use the fcShowNames command to verify your changes.
The output in the Node Name column of the of the fcShowNames command should no longer match the
output previously saved before using wwnGlobalClear.
Final Diagnostic Tests
After a SNC 6101 has been replaced, a diagnostic check should be performed to ensure that it now operates
properly.
Final Test Preparation
1
Connect a service terminal to the SNC 6101.
For information about how to do this, refer to
on page 21.
2
Power ON the Scalar 100 and wait until the SNC 6101 finishes booting.
3
Press the Enter key on the service terminal to display the prompt.
4
From the service terminal, enter the diagBoot command.
5
Wait until the SNC 6101 has finished booting into diagnostic mode.
6
From the service terminal, enter the showBox command.
7
Verify that the SNC 6101 accurately displays the channel information.
8
Proceed to
Fibre Channel Tests
Fibre Channel Tests
1
Connect the service terminal to the service port.
Instructions for doing so are provided in
page 21.
2
Press Enter on the service terminal to display the prompt.
3
From the service terminal, enter the showBox command.
For more information about this command and an example of its use, refer to the SNC Firmware 4
User's Guide.
4
Confirm that the Fibre Channel connections are correctly displayed.
5
If the Fibre Channel connections do not display correctly in the showBox display, remove the GBIC and
replace it with a known-good GBIC.
Proceed to
Ethernet
SNC 6101 User's Guide
on page 41
To cable the service port to your laptop/desktop computer
Test.
To cable the service port to your laptop/desktop computer
on
41
Advertisement
Table of Contents
