Table of Contents
Advertisement
SCSI Wrap Test (
Test Not Supported (
Unmake FMR Tape (
Putting the LTO Standalone in Maintenance Mode
Perform the following steps to place the drive in Maintenance Mode.
1.
Verify that a cartridge is not in the drive.
2.
Press the Unload button three times within a one second interval.
The state of the front panel indicators will be as shown in the following table:
Indicator
Status LED
Single-character display
LCD
Diagnostic or Maintenance Functions
To select a diagnostic or maintenance function:
1.
Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
2.
Press the Unload button once per second until the specific function code appears on the single-character display and the
function name appears on the second line of the LCD, as shown in the following table:
Indicator
Status LED
Single-character display
LCD
Function Name
3.
Press and hold the Unload button for three seconds. The drive will perform the function you selected.
4.
If the function requires you to insert a cartridge,
message that prompts you to insert a cartridge. Within 60 seconds, insert a cartridge or the drive will exit Maintenance
Mode.
26
Troubleshooting and Diagnostics
6
)
7
)
8
)
State, Character, or Message
Maint Mode: Select
Exit Maint Mode
If a cartridge is in the drive, it will eject the cartridge the first time that you press the
Unload button and the drive will not be placed in Maintenance Mode. To continue
placing the drive in Maintenance Mode, perform the previous step.
State, Character, or Message
Maint Mode: Select
Drive R/W Diagnostic
If you cycle past the desired function code, press the Unload button once per second
until the function code reappears on the single-character display.
For use by Support Personnel (
For use by Support Personnel (
Amber, solid
0
Note
Amber, solid
1
Note
c
will appear on the single-character display and the LCD will display a
p
)
u
)
Function Code
Advertisement
Table of Contents
Troubleshooting
