Welbilt FQ80 Operation Manual page 69

DISPLAY
OQS – FILTER NOW?
OIL LEVEL TOO LOW
START FILTRATION
DRAINING
FLUSHING
ALERT DRAIN CLOSING REMOVE
TOOLS
FILLING
MEASURING OIL QUALITY
FILLING
TPM - XX
3. Select OQS (Oil Quality Sensor) - FILTER.
4. Press the √ (check - YES) button to start filtration. If the X
(NO) button is selected, filtering is cancelled, and the fryer
resumes normal operation.
5. Displayed if the oil level is too low. Press the √ (check - YES)
button to acknowledge issue and return to idle cook mode.
Check to see if the JIB is low on oil. If JIB is not low and this
continues to occur, contact your FAS.
6. Press the BLUE button to start filtration or the X button to
cancel the filter.
7. No action required as oil drains into filter pan.
8. No action required while the return valve opens, and the vat
is flushed with oil from the filter pan.
9. Ensure that all tools are removed from the frypot prior to
the drain closing to prevent damage to the drain.
Keep all items out of drains. Closing actuators may cause
damage or injury.
10. No action required while the OQS sensor is filled.
11. No action required while the OQS sensor calculates the oil
quality value of the oil.
12. No action required while the vat is filled.
13. If OQS = Text and if TPM reading is below OQS SETUP –
DISCARD NOW and DISCARD SOON limits, the TPM value is
shown in the green TPM box in lower right corner. Proceed
to step 17.
If OQS = Text and if TPM reading is below OQS SETUP –
DISCARD NOW but above DISCARD SOON limits, the TPM
value is shown in the yellow TPM box in lower right corner.
Proceed to DISCARD SOON in step 15.
If OQS = Text and if TPM reading is above OQS SETUP –
DISCARD NOW limits; the TPM value is shown in the red TPM
box in lower right corner. Proceed to DISCARD NOW in step
16.
If OQS = Number proceed to TPM - XX in step 14.
14. Press the √ (check - YES) button to continue. If the TPM
reading is above OQS SETUP – DISCARD limits, proceed to
step 16, otherwise proceed to step 17.
2-18
ACTION
DANGER