Welbilt FQ80 Operation Manual page 26

DISPLAY
SETUP COMPLETE
□ FILTER TIME
SETUP COMPLETE
□ FILTER OFF TIME
SETUP COMPLETE
□ FILTER OFF SETTINGS
47. Press the √ (check) button.
48. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
49. Press the FILTER TIME button. The Filter Time option is
used to set the elapsed time in hours before a filtration
prompt. This option is useful in lower volume stores,
where filtration is desired more often than the amount
the cook cycles would generate.
50. Press the √ (check) button to continue or press the
number button and enter the number of hours in
between filter prompts. (ex. after every two hours, enter
as 2) and press the √ (check) button. (By default, the time
is set to 0 hours to disable)
51. Press the √ (check) button.
52. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
53. Press the Filter Off Time button. The Filter Off Time
option is used to set times in which the filter prompt is
disabled (ex. noon rush).
54. Select ON to enable FILTER OFF TIME. Select OFF to
disable FILTER OFF TIME.
55. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
56. Press the Filter Off Settings button. The Filter Off Settings
option is used to set the times in which the filter prompt is
disabled (ex. noon rush).
NOTE: If FILTER OFF TIME is disabled (OFF), this option
is grayed out and not available.
57. Use the up down arrows to scroll between M-F 1 thru SUN
4. There are a total of 12 periods which can be
programmed for filter prompt lockout. Select the field to
edit the start and stop times of when the filter prompt
should be suspended. Select AM/PM. Once the times are
selected press the check button to save the setting. (The
example at the left shows on Monday – Friday no filtering
is desired during a lunch rush from 11:00 AM until 2:00
)
PM.
58. Once the times are selected press the √ (check) button.
1-17
ACTION