Welbilt FQ80 Operation Manual page 32

DISPLAY
SETUP COMPLETE
□ SCREEN SAVER
SETUP COMPLETE
□ ALARM ATTRIBUTES
□ SHAKE ALARM MODE
SETUP COMPLETE RESTART THE
SYSTEM
□ HOLD ALARM MODE
SETUP COMPLETE RESTART THE
SYSTEM
□ ALARM TIMER
SETUP COMPLETE RESTART THE
SYSTEM
□ TEMPERATURE
126. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
127. Press the Down button.
128. Press the Screen Saver button. This is used to set the
amount of time, after the controller is turned off, before
going into a screen saver mode. Use the up down arrows
to adjust time. (Default is 15 minutes.)
129. Use the up down arrows to change the brightness of the
screen. Brightness has nine levels with 100 being the
brightest and 10 the darkest.
130. Press the √ (check) button when complete.
131. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
132. Press the Alarm Attributes button
133. Press the Shake Alarm Mode button. Select Auto or
Manual. The Shake Alarm Mode allows the user to select
between auto or manual shake alarm cancel.
134. Press the √ (check) button.
135. Press the Hold Alarm Mode button. Select Auto or
Manual. The Hold Alarm Mode allows the user to select
between auto or manual hold alarm cancel.
136. Press the √ (check) button.
137. Press the Alarm Timer button. These settings allow the
user to select the amount of time before auto cancelling
the shake alarm timer or hold alarm. Default settings are
5 seconds.
138. Press the √ (check) button.
139. Press the Back button two (2) times.
140. Press the Temperature button.
1-23
ACTION