Welbilt FQ80 Operation Manual page 54

DISPLAY
FLUSHING
ALERT DRAIN CLOSING REMOVE
TOOLS
FILLING
PREHEAT
NOTE: If the filter pan is removed during filtration, the filtration process stops and resumes once pan is
reseated into place.
Should the quick filtration procedure fail or if ALL the oil isn't completely returned during filtration, the
system may proceed to an incomplete filtration function. In some cases, an error message may be
generated. Follow the instructions on the controller to clear the error, complete the filter and return ALL
the oil.
When FILTER BUSY is displayed, the system is waiting on another vat to be filtered or waiting on another
issue to clear. Press the √ (check - YES) button and wait 15 minutes to see if problem is corrected. If not,
call your local FAS.
Do not drain more than one frypot at a time into the built-in filtration unit to avoid overflow
and spillage of hot oil that may cause severe burns, slipping and falling.
The filter motor is equipped with a manual reset switch in case the filter motor overheats,
or an electrical fault occurs. If this switch trips, turn off power to the filter system and allow
the pump motor to cool 20 minutes before attempting to reset the switch (see photo below).
Use caution and wear appropriate safety equipment when resetting the filter motor reset
switch. Resetting the switch must be accomplished with care to avoid the possibility of a
serious burn from careless maneuvering around the drain tube and frypot.
7. No action required as debris is flushed from the vat.
8. Ensure that all tools are removed from the frypot prior
to the drain closing to prevent damage to the drain.
Keep all items out of drains. Closing actuators may
cause damage or injury.
9. No action required as the vat refills.
10. No action required as the fryer heats to setpoint.
11. Fryer is ready for use. Displayed once fryer reaches
setpoint.
DANGER
WARNING
WARNING
2-3
ACTION
DANGER