Welbilt FQ80 Operation Manual page 25

DISPLAY
SETUP COMPLETE
□ F° TO C°
YES
CONFIRM
COMPLETED SUCCESSFULLY
□ SOUND
SETUP COMPLETE
□ FILTER ATTRIBUTES
□ FILTER AFTER
33. Press the √ (check) button when complete.
34. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
35. Press the Back button three (3) times.
36. Press the F° TO C° or F° TO C° button.
NOTE: F is used for Fahrenheit, C is used for Celsius
37. Select YES to toggle the temperature scale.
NO
38. Press the √ (check) button when complete.
39. Press the Sound button.
40. Use the up down arrows to change the volume level and
tone. Volume has nine levels with 1 being the softest and
9 the loudest. Tone has three frequencies from 1-3. Use
different frequencies to customize the sound.
41. Press the √ (check) button when complete.
42. Press the smaller √ (check) button inside the SETUP
COMPLETE box.
43. Press the Down button.
44. Press the Filter Attributes button.
45. Press the FILTER AFTER button.
The auto filtration mode uses two measures before
prompting to filter. One checks for cook cycles which is
adjusted in the FILTER AFTER setting and the other checks
for time which is adjusted in the following section FILTER
TIME setting. The prompt for filtration is initiated by
whichever occurs first; either the number of cycles
elapsed or time elapsed. The FILTER AFTER option is used
to set the number of cooking cycles which occur before
the filtration prompt is displayed. Default is 15. If no
prompts are desired set to 0 to disable.
46. Press the √ (check) button to continue or press the
number button and enter the number of cooks between
filter prompts. (ex. after every ten cooks it prompts to
filter, enter as 10 and press the √ (check) button
1-16
ACTION