Leica DM2000 Operating Manual page 35

• Engage the condenser-side prisms one after
the other and focus the telescope on the dark
diagonal compensation stripe (40). by slightly
loosening the clamping ring (36.2) and moving
the eye lens (36.1). The compensator must be
inactive, i.e. the engraving λ must be on the
lower side of the analyzer or the λ and λ/4
compensator must be removed.
The dark stripe should be in the center of the
brighter circular area. If not, proceed as follows:
Fig. 40
Objective pupil with correctly centered compensation
stripe.
• Make sure that the right-hand centering
screw for the light rings is not turned too far
inward or it may obstruct the movement of the
prism with the left-hand key.
• Push in the left-hand centering key on the
back of the condenser until it clicks into
position and rotate it until the stripe is in the
center of the circle.
The right-hand key is not required.
7. Start-up
35