Leica DM2000 Operating Manual page 21

Leica DM2000 only:
Replacing the Lamp of the Iintegrated Illumina-
tion
The transmitted-light illumination with a low-
voltage tungsten halogen lamp (Fig. 12) is
integrated in the base of the microscope and is
accessible from the right-hand side.
• Remove the insert (12.2).
Caution!
The lamp may still be hot!
• Remove the lamp.
Caution!
Do not remove the new lamp's dust cover
until you have installed the lamp. Avoid
fingerprints on the lamp.
Fig. 12 Transmittedlight illumination in microscope base
1 Tungsten halogen lamp
2 Insert
1 2
• Insert the new lamp with the dust cover
straight into the socket until it stops. Be sure
that the lamp is inserted straight.
• Remove the lamp's dust cover.
• Replace the insert (12.2).
Leica DM2500 only:
Replacing the Lamp in Lamp Housing 107/2
This lamp housing is used with a 12V 100W halo-
gen lamp, which is already mounted.
In case the lamp has to be removed:
• Remove the fastener screw on the housing
(Fig. 13).
• Remove the housing by pulling it upward.
• Remove the lamp.
Fig. 13 Lamp housing 107/2
Releasing the fastening screw
6. Assembly
21