Connecting The Black & White Printer - GE Voluson P6 Service Manual

GE H RAFT
EALTHCARE
DIRECTION 5459672-100, R
3-5-2 Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in:
2.) Connect the Black & White printer according to correct connection scheme as described in
Figure 3-6 on page 3-13
NOTE: The Black & White printer should be connected to the USB2 port of the Voluson® P8 / Voluson® P6´s
PC-part.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson® P8 / Voluson® P6 system as described in
3-23. All software drivers are pre-installed for the designated Black & White printer only.
5.) After physical connection to the Voluson® P8 / Voluson® P6 system, assign the printer to a remote
key (P1, P2, and P3 ) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING WARNING
IEC 60601-1 respectively UL 60601-1.
!! WARNING:
3-12
6 DRAFT (J
EVISION
3-46.
Section 3-5 - Connection of Auxiliary Devices
17, 2013)
ANUARY
Section 3-6-3 on page
Section 3-7-6 "Remote Control Selection" on page
Section 3-7-5 "Adjustment of Printer
V ® P8 / V
OLUSON OLUSON
P S M
ROPRIETARY ERVICE
3-27.
Section 3-6-2 on page
3-53.
® P6
ANUAL