GE Voluson P6 Service Manual page 376

GE H DRAFT
EALTHCARE
DIRECTION 5459672-100, R
8-3-5 System Software - Installation Procedure (FMI from DVD)
9.) Click the FMI FROM DVD button (see:
Software.
10.)Verify that only the DVD drive is connected to the system, then click OK
Figure 8-11 Verify that USB devices are disconnected, then click OK
11.)To start update procedure click YES
The system saves Full Backup in silent mode on R:, then it reboots into LINUX.
A silent "Rollback" image from C:\ is stored on R:\.
After executing all LINUX commands, the system reboots again.
NOTE: If the currently installed software has to be upgraded to a newer version, and the system DVD being
used is SW 13.0.0 or higher, a new software specific "Permanent key is required.
• Enter the appropriate "Permanent Key"
If the entered Permanent key is correct, following window appears, confirm with ENTER.
•
6 DRAFT (J
EVISION
Figure 8-12 Yes - start update procedure
Figure 8-13 insert Permanent Key
Figure 8-14 confirm Permanent Key
Chapter 8 - Replacement Procedures
17, 2013)
ANUARY
Figure 8-10 on page
(Figure 8-12 below).
select OK and confirm with ENTER.
(calculated in OKOS),
V ® P8 / V
OLUSON
P S
ROPRIETARY ERVICE
(cont'd)
8-12) for updating the System
(Figure 8-11
Note: This Example shows
fictional numbers.
® P6
OLUSON
M
ANUAL
below).
8-13