Connecting The Black & White Printer - GE Voluson P8 Basic Service Manual

GE DRAFT
DIRECTION 5775469, R
3-5-2 Connecting the Black & White Printer
1.) Power OFF/Shutdown the system as described in:
2.) Connect the Black & White printer according to correct connection scheme as described in
Figure 3-6 on page 3-14
NOTE: The Black & White printer should be connected to the USB2 port of the Voluson™ P8/Voluson™P6´s
PC-part.
3.) When all the cables are connected, press the Power ON switch on the Black & White printer.
4.) Power ON/Boot up the Voluson™ P8/Voluson™P6 system as described in
3-25. All software drivers are pre-installed for the designated Black & White printer only.
5.) After physical connection to the Voluson™ P8/Voluson™P6 system, assign the printer to a remote
key (P1, P2, and P3 ) as described in
6.) Verify the correct settings in the printer "Properties", see:
Settings" on page
After each installation, the leakage currents have to be measured according to
WARNING WARNING
IEC 60601-1 respectively UL 60601-1 and ANSI/AAMI ES60601-1.
!! WARNING:
3 DRAFT (J
EVISION
3-49.
Chapter 3 - Setup Instructions
19, 2018)
ULY
Section 3-6-3 on page
Section 3-7-8 "Remote Control Selection" on page
Section 3-7-7 "Adjustment of Printer
V ™ P8/V
OLUSON OLUSON
B S M
ASIC ERVICE ANUAL
3-28.
Section 3-6-2 on page
3-53.
™P6
3-13