GE Voluson P6 Service Manual page 353

GE H RAFT
EALTHCARE
DIRECTION 5459672-100, R
CW quant TxFreq out of range
CW_BaseLinePos Out Of Range
CW_Gain Out Of Range
CW-hardware doesn't support
CW-TxFrequency == 0
D:\\SERVICE\\ConfIndexFile is corrupted Action: restart the system
Data are not saved or sent to DICOM Server!
dDistanceFocusReferenceBF_ToProbeSurface out of valid range Action: restart the
system
Delete error (Backup data could not be deleted.)
Density Out Of Range
Device is not a DVD/CD rec.
Different software error (Backup data was made on another system with a different
software version.)
Disc is full!
Display:Rect Region fails
Do you really want to delete?
Do you really want to format this DVD?
done is low!
Doppler-Txfrequency out of range
Downgrade error (Backup data was made with a software version higher than the
installed version.)
DVD Recorder communication error! Check Recorder cables and try again.
Make sure DVD Recorder is connected to US machine.
DVD Recorder not properly connected or turned off!
Check connection from US machine to Recorder, Recorder has power and is on.
DVD Recorder timeout error! Check Recorder cables, DVD,... and try again.
ECG Module not connected.
ECG_Consumer: memory allocation failed
Electronic user manual not installed. Please install.
End Bandwidth too big
End ET too big
End frequency too big
7-64
6 DRAFT (J
EVISION
Error Messages
Section 7-13 - Error Messages
17, 2013)
ANUARY
restart the system
Press ok and save this user-setting once again.
Press ok and save this user-setting once again.
pencil probe + CWHardware not available, restart the system
restart the system
restart the system
restart the system
restart the system
check storage destination of Full Backup
(e.g., DVD/CD, insufficient rights on target Network drive,
write protection on USB-drive)
Press ok and save this user-setting once again.
reconnect the device
This backup cannot be restored by the user.
use a new CDR for writing data to CD
restart the system
restart the system
restart the system
load appropriate backup for installed version
check DVD connections, check if DVD is switched on
check DVD connections, check if DVD is switched on
check DVD connections, check if DVD is switched on
connect ECG Module
restart the system, reinstall UISAPP, contact online
center(OLC)
install Electronic User Manual (EUM) and try it again
restart the system
restart the system
restart the system
V ® P8 / V
OLUSON OLUSON
P S M
ROPRIETARY ERVICE
Actions
® P6
ANUAL