Wing Tail; Wing Tail Detail - GRAUPNER S1024 Reference Manual

Graupner mz-32 / mz-16 Help Reference Manual
You can assign a switch (Input control) to activate a mix or control surface setting by
tapping on the respective Ctrl field.
The values in the fields Rate A and Rate B will determine the amount of deflection for the
control surface in the mix.
To change the value, tap on the Rate A or Rate B field to activate the edit toolbar. Use the
slider control bar for large value changes or the arrow keys for changes in small steps.
Tapping on the chain link icon will link Rate A and Rate B for the simultaneous change of
the values.
The trim field allows you to set the sensitivity of the trim when the mix is active. The default
value of 100 provides normal trim control while a value of 50 will reduce its sensitivity by
50%.
F04S2
To activate or deactivate the mix, tap on the respective Act icon of a mixer.
You can assign a switch (Input Control) by tapping on the respective Ctrl field of a mixer.
F05S1
set as global the mix will be permanently active unless a control is assigned to turn the mix
on or off. Note: The Act/Action icon and Ctrl assignment in this section is the same as in
the main Wing Tail section.
You can assign a switch (Input Control) to activate a mix or control surface setting by
tapping on the respective Ctrl field.
The values in the fields Rate A and Rate B will determine the amount of deflection for the
control surface in the mix.
To change the value, tap on the Rate A or Rate B field, this will activate the edit toolbar.
Use the slider control bar for large value changes or the arrow keys for changes in small
steps.

WING TAIL

In the Wing Tail menu you can activate and deactivate
various mixers between the wing and the stabilizer, set
mixing rates and assign switches (Input Control).
For example, use the Flap to Elevator mix to
compensate for pitch changes during the deployment
of flaps, the Elevator to Ailerons and Elevator to Flaps
for a Snap Flap setting.
The Function column lists the names of available
control surface mixers. Tapping on the mixer name
field (Function column) will highlight the affected
channels on the Detail Set image.

WING TAIL DETAIL

Tapping on the Detail Set image will provide additional
settings for rate, offset and offset switch (Input
Control). The available settings vary based on what
mixer has been selected.
In the Wing Tail Detail menu, you will set the rates for
the control surfaces that are part of the mix.
Each mix can be global or phase dependent. Tapping
the Group icon toggles between the global or phase-
dependent setting.
The mix can be activated by tapping on the Action icon
which will enable the mix for that phase. If the mix is
Page 26 of 51 Help-Ref-EN-V2.7