I/O Set - GRAUPNER S1024 Reference Manual

Graupner mz-32 / mz-16 Help Reference Manual
G03S1
channels for output on the DSC and/or Data port.
The DATA fields control the output protocols available on the DATA port.
SUMD – This is Graupner specific protocol. You can set the number of output channels and
the channel mapping for your setup.
SP – This is a Spektrum specific protocol. Tapping on the field next to SP will open another
window for additional settings. Select Mode, Channel, Bind and Range Test for an external
Spektrum RF module
S-BOX – View the telemetry information on the screen of a connected Graupner Smart-
Box.
EXT-M – View the telemetry information on the screen of a connected Smart-Box.
CRSF – When a TBS CROSSFIRE module is used the proper version must be selected. If
required, you can map the channels.
Tapping on the DATA port icon will turn the power to the attached module (5V) On and Off.
G04S1
Contr. Center beep : Activates/deactivates the beeping
sound on a LV/DV control when centered.
Radio On/Off Soun.. : Turns the startup and shutdown
sound on or off.
@BT Speaker : When a Bluetooth headset is activated
the internal speaker can be switched on or off
I/ O SET
The I/O set menu is used to configure what channel
information/data
connectors of the radio. The switch positions can be
changed by tapping on the switch symbols.
Inputs and outputs can be configured for certain data
formats.
Before Mix – PPM In – Shows the number of channels
that are recognized by the PPM DSC input and available
for student mode operation.
Before Mix – PPM Out – Selection of the output
waveform (normal/inverted) and the number of
Page 47 of 51
is available at the
Help-Ref-EN-V2.7
back-panel