Switch Set; Timers Set - GRAUPNER S1024 Reference Manual

Graupner mz-32 / mz-16 Help Reference Manual
menu.
The switch set menu has additional pages that can be accessed with the arrow keys (top 2
keys left of screen) or by swiping the screen.
The secondary screen shows the current position of the digital trims (DT), knobs (DV),
levers (LV) and switches (SW). Moving each control or switch will animate the control on
the screen while tapping on the control will open the configuration dialog.
The additional screens on the switch set menu are for future development.
B13S1
The group column shows if the timer is global or phase dependent. To change group status,
tap on the group icon.
You can change the timer type by tapping on the type column.
The Act icon indicates if the timer is active or disabled.
Tapping on the Detail icon opens the timer set detail menu.
B10S1

SWITCH SET

In the Switch Set menu, you can set the switching
point for controls, sliders and switches that can be used
for activating mixes and controls when a logic control
is used. It also allows you to set the trim steps and
speed for the digital trims that are used with control
surfaces such as ailerons and elevator.
Each trim and control can be independently set. To
view the detail menu, tap on the DT, ST, LV or DV
control.
In the configuration dialog tap on the control you would
like to make changes for to bring up the switch detail
You can set the following parameters.
Switching Position – The default is set at 75% for each
travel direction. This indicates that when the control is
moved past the +75% or -75% position, a trigger
event will happen that can be used with a logical
switch. Lowering the values will cause the trigger point
to be closer to the center point of the control.
Digital Trim – The default values will determine how
many steps a digital trim control will have and how fast
it will travel. Setting the steps to zero will disable the
digital trim travel.

TIMERS SET

Depending on your radio model you can create up to 6
timers for time or lap recording. Timers can be either
global or phase dependent.
Adding a new timer is done by tapping on the + sign
or on the number of an existing entry to bring up the
selection toolbar.
When tapping on the + sign, the timer type dialog
appears where you can select the type of timer, lap or
start/stop timer.
When the selection toolbar is active, you can perform
delete, re-order or rename functions.
Page 20 of 51 Help-Ref-EN-V2.7