Timers Set Details; Timer Set Lap Details - GRAUPNER S1024 Reference Manual

Graupner mz-32 / mz-16 Help Reference Manual
cues from the Pre-Alarm settings. This is usually done during the last phase of the timer
countdown.
Pre Alarm – The Pre Alarm settings determine the type and frequency of the alarms received
during the final countdown. Tapping on the vibrating icon will activate the vibration
feedback. You can choose from up to 10 different vibration types. Tapping on the pre-alarm
field will display the pre-alarm dialog with the following options:
Mode – determines if the notifications are voice or beep types.
Cycle – determines how often they are repeated.
Countdown – determines if the timer will provide a countdown during the last 10 seconds
of the timer run.
Alarm Notification – Tapping on the vibrating icon will activate the vibration feedback when
the timer reaches its countdown end. Tapping on the voice field will bring up the file
manager from where you can select a voice file to play at countdown end.
Power Init – Checking the power init box will clear the timer each time the model is loaded.
When left unchecked the last timer value will remain active when the model is loaded.
Group – Tapping on the group icon will change the timer from group to phase dependent.
Type – Tapping on the type field brings up the timer type dialog to change the active timer
type. When a lap timer type is selected, a timer detail icon will show to access the laps
detail menu.
Start/Stop/Reset – Tapping on any of the fields will bring up the input control dialog for
controlling the timer.
B10S2
B10S3

TIMERS SET DETAILS

In the Timer detail menu, you can set all the details for
your timer.
Run Time - Shows the total time the timer has been
running. You can reset the time by either tapping on
the reset icon or by assigning a control.
Set Time – Tapping on the Set Time field will bring up
the time dialog to set the time for the timer to run. A
timer can either count up or count down. To change
the count type, tap on the arrow key.
Pre Time – Tapping on the Pre-Time field allows you to
set a time for when you would like to start receiving

TIMER SET LAP DETAILS

In the timer lap detail menu, you can review the lap
time for each lap recorded at its trigger point.
In the top bar, the total time is shown with the total
laps recorded. The reset icon resets and clears all lap
times.
Best – shows the best lap time and best lap number.
Slowest - shows the slowest lap time and slowest lap
number.
Average – shows the average of between the best and
slowest lap number.
Page 21 of 51 Help-Ref-EN-V2.7