Table of Contents
Advertisement
Graupner mz-32 / mz-16 Help Reference Manual
be notified if a switch is not in its stored start position by showing the Switch Set detail
menu. If you wish to continue you can either tap on the Pass button or position your
switches and controls at their proper positions.
S02S1
Tap on the plus sign of the edit tool bar to select from a list of available notifications.
Note: Although you can select values from each sensor type, there will be no notifications
unless the sensor is installed.
Check the Telemetry menu for currently active sensors.
Tap on the Range field of a warning message to set its trigger threshold. The edit tool bar
will be activated. Use the slider control bar for large value changes or the arrow keys for
single digit changes.
S03S1
you can activate or deactivate notifications in the Sensor Notice menu.
Tap on the sensor field name on top of the screen to select a sensor.
Available notice settings vary depending on the
warning message.
Tap on the Play button to test the notice, based on the
current settings.
Notice No. 9 is activated by tapping on the blue Store
field.
Place all your switches in the desired start positions
before tapping on Store. If you also wish to store the
position of your controls (LV/DV) position them at the
desired position and activate the value icon on the
notice dialog. When turning on the transmitter you will
USER NOTICE
Use the User Notice menu to configure telemetry
notifications and warning messages.
Each sensor generates its own set of values that are
transmitted from the receiver to the transmitter for
further processing and evaluation. When a value meets
the criteria for the trigger as set in the Range field, the
transmitter will issue the configured Notice.
There are a maximum of 24 user notifications for each
model available.
Tap on the No field to add, delete or re-position the
notification.
SENSOR NOTICE
In the Sensor Notice menu you can activate additional
telemetry notifications which are not listed in the User
Notice menu.
Each sensor such as the Graupner General Air Module
or Vario may generate additional telemetry information
which can trigger notifications depending on the preset
values for the sensor.
These preset values are set through the telemetry
ASCII menu in the sensor Set Warning page. Check the
sensor module manual for available telemetry options.
After setting the preset values in the sensor module
Page 38 of 51
Help-Ref-EN-V2.7
Advertisement
Table of Contents
