Table of Contents
Advertisement
7. Within the specified duration, 99 seconds of the range test,
move away from the model while moving the control sticks.
– If there is an interruption in the connection at any time
within a distance of approx. 50 m or 165 feet, try to repro-
duce it.
8. If needed, switch on an existing motor to check the interference
immunity additionally.
9. Keep moving away from the model until perfect control is no
longer possible.
10. At this point, wait for the end of the test period with the still
operational model or tap the value field to end the test.
– As soon as the range test is completed, the model should
respond to control commands again. Do not use the system
but contact the
condition.
11. Carry out the range test before each commissioning of a model
and simulate all control movements that occur in practice. The
range must always be at least 50 m or 165 feet on the ground
to ensure safe model operation.
CAUTION
!
Never start the range test on the transmitter during nor-
mal model operation.
Output swap
Since the transmission of the control channels to the receiver is
optimized on the transmitter side, taking into account of the mod-
el-specific requirements and used channels, all required control
channels/outputs must be assigned in the „Output swap" menu of
the basic menu.
This assignment takes place automatically during the creation of
a model memory and as a result of manual renaming of the
required servo outputs in the „Servo settings" submenu of the
basic menu.
Therefore control channels/outputs, that are used but have not
been renamed, must either be assigned manually in this menu or
the „Automatic assignment" display can be shown by tapping the
symbol
at the top edge of the display and then by tapping the
blue field to trigger an automatic assignment.
38 / 64
Graupner
service center under imperfect
33040_mc32exHoTT_V1.00_en
Stick Set
If the center position of the self-neutralizing joystick does not cor-
respond to exactly 0% control travel, this can be corrected in this
menu.
Check stick Set step-by-step
1. Switch to the „Model list" submenu of the „green" basic menu.
2. Initialize a free model memory with any model type.
3. Do not make any further adjustments or adjust any trims.
4. Press the top button of the right keypad to bring up the Servo
View menu: If all self-resetting sticks are in their middle position,
the display of control channels 1...4 or 2...4, if the C1 stick is
switched to non-self-resetting, should look like the figure on the
left.
– If the display looks as shown, everything is okay and the pre-
viously created model memory can be deleted again.
– If the display deviates from the desired values, it can be cal-
ibrated in the "Stick calibration" submenu of the "blue" sys-
tem menu.
Stick Set step-by-step
1. Leave the model memory enabled as previously created in
"Check Stick Calibration Step-by-Step".
2. Switch to the „Blue" tab of the „System" menus.
3. Touch the Stick Set field.
The corresponding menu opens.
4. Tap the symbol
stick calibration following the help text instructions.
33040_mc32exHoTT_V1.00_en
aat the top of the screen and perform the
39 / 64
Advertisement
Table of Contents
