Network Settings/Wi-Fi Settings - Grandstream Networks GXV3350 Administration Manual

Users could select "DHCP" or "Static IP".
• DHCP: Obtain IP address via a DHCP server in the LAN. All domain values for static IP/PPPoE are
unavailable, even though the values have been saved in the flash.
IPv4 Address Type
• Static IP: Manually configures IP Address, Subnet Mask, Default Router's IP Address, DNS Server 1
and DNS Server 2.
By default, it is set to "DHCP".
IP Address Defines the phone's static IP address if the static IP is used.
Subnet Mask Determines the network's subnet mask if the static IP is used.
Default Gateway Defines the network's gateway address if the static IP is used.
DNS Server 1 Configures the primary DNS IP address if the static IP is used.
DNS Server 2 Configures the secondary DNS IP address if the static IP is used.
Layer 2 QoS
When Different Networks for Data and VoIP Calls set to Yes, then this option will be applied for
802.1Q/VLAN Tag
VoIP traffic. Assigns the VLAN Tag of the Layer 2 QoS packets for Ethernet for VoIP Calls. The Default
(Ethernet) for VoIP
value is 0.
Calls
802.1x Mode
Enables and selects the 802.1x mode for the phone system. The supported 802.1x modes are: EAP-
MD5, EAP-TLS, EAP-PEAP
802.1x mode
The default setting is "Disable".
Enters the identity information for the selected 802.1x mode. (This setting will be displayed only if
802.1x Identity
802.1 X mode is enabled).
Enters the secret for the 802.1x mode. This option will appear when 802.1x mode is EAP-MD5 or
802.1x Secret
EAP-PEAP.
Uploads the CA Certificate file to the phone. (This setting will be displayed only if the 802.1 X mode
CA Certificate
is enabled)
Loads the Client Certificate file to the phone. (This setting will be displayed only if the 802.1 X TLS
Client Certificate
mode is enabled)
Loads the private key file to the phone. (This setting will be displayed only if the 802.1 X TLS mode is
Private Key
enabled)

Network Settings/Wi-Fi Settings

Wi-Fi Basics
WiFi Function Enables/disables the Wi-Fi feature. The default setting is "Disable".
Table 20: Network Settings/Ethernet Settings